Export in .obj and .zmbx into Blender 2.92 causing mesh issues
zepherdragon started this discussion in Bug Reporting

On the 1x1, 1x2, 2👨, 2x4 plates (may be more plates), the LEGO word mesh on one of the studs has a dome in the middle of the stud which is causing the part of the LEGO word mesh to be missing near it. I have exported in both .obj and .zmbx to see if it is a file type issue but the bug is the same with both file types. I would attach an image but apparently that is not available.

4 replies · Page 1 of 1

I uploaded the image as my profile image so you can see what I'm talking about.

Yeah, that same problem happens on some of my real LEGOs too. It's from the injection mold point. I'm pretty sure Scrubs modeled it in there to add some realism.

I don't think it's realistic to have it on every brick. I hope they remove it.

Avatar of Scrubs
Administrator

This is the mark of the injection molding gate often located on top of certain studs. You can complain to LEGO if you do not like where they are located on their moulds 😉

Advertising
3 participants
Avatar of zepherdragon
Avatar of B1Trash
Avatar of Scrubs

LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2024 The LEGO Group.

Mecabricks, the Mecabricks logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©2011-2024 Mecabricks.