Whenever I move a brick in the workshop, it moves too far and usually doesnt fit with bricks below, and also goes too far, so i cant align it with the edges.
So, my main question is could I change how far the snap goes? and on another note: even when i use the snap option i cannot rotate it or else it wont snap anymore.
I don't know of a way to edit the snap. However if it helps, when you have snapped a piece, and then hover over that piece with your mouse, you can click on the dots, symbolizing an important part of that piece, (a clip, a stud, a hole for a bar to fit in, etc.) and you can then rotate from that point. For example, you could rotate where two pieces connect at the stud, or if you have a ball in a joint, you could rotate one of the pieces from the joint. Thus keeping the two pieces snapped together, while one piece moves separate from it. Or if you hold ctrl and click on multiple pieces (highlighting them in red) you can move as one connected piece.
LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2024 The LEGO Group.
Mecabricks, the Mecabricks logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©2011-2024 Mecabricks.