Hello, well I made a made a remake of part 3626d762 I loaded the decoration into the part manager onto uv2 and it came out looking like this:
The decoration looks like this:
Could you help me out?
Can you re-do the images in the post? They didn't come out for some reason.
Edit: I was able to take a look at your images. It looks like you built a decoration that is compatible with the stacked front-and-back UV map. This is uv2 for 3626v2 (hollow stud), but for the base 3626 (blocked open stud) that map is in the uv3 slot. The easy way to tell is to check the image preview under Textures in the right hand sidebar.
Don't worry about it. I just realised that it was my mistake. I ticked uv2 on right side in textures but I didn't change the uv under Decorations. My mistake. 😖
I also just submitted the part for approval.
LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2024 The LEGO Group.
Mecabricks, the Mecabricks logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©2011-2024 Mecabricks.