I was going to make a custom print for a baby piece only to find out that the baby pieces don't seem to have a 3D model that shows up in the library when you select them, and when I type the number for any of the baby pieces into the configuration selection, it says it isn't a piece in the library.
This is because the part hasn't been converted to the new parts system yet, and only pieces in the new system appear in the configuration tab, have 3D views in the parts manager, and are able to have custom decorations applied. All pieces will eventually be converted, but it is very time consuming to do. If you use Blender or any other 3D modelling software, you can apply a decoration there, otherwise you aren't able to decorate it yet.
thanks for letting me know
LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2024 The LEGO Group.
Mecabricks, the Mecabricks logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©2011-2024 Mecabricks.