Rendering custom minfigure prints
construx12345 started this discussion in Help and Tips
Is there a possible way to add custom minifigure prints from a jpg or png file?
1 reply · Page 1 of 1
Just go a few sections under in the forum to find the answer...
https://www.mecabricks.com/en/forum/topic/2925
Advertising
2 participants
LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2024 The LEGO Group.
Mecabricks, the Mecabricks logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©2011-2024 Mecabricks.