how to use the new grouping chart
lego11 started this discussion in General Discussion

how do you use the new grouping graph?

4 replies · Page 1 of 1

Yes, please, I don't get it either. Is there a video tutorial available maybe?

Drag and drop...

thanks!

Well, maybe I'm doing sth wrong, but with me, the drag and drop ist terribly umständlich.
Say I have a (rather brick-intensive) model and after some time working on it, I need to add a new part to an existing group.
The old way I would have highlighted the part and klicked on "add to group" in the parts-list/graph on the right side.
Now what I have to do is to locate the desired part manually in the list/graph by scrolling down and down, then drag it all the way up again, which takes rather long due to the constant slow pace, especially if we're talking about a model with 1000+ bricks.
Additionally I can't stop the list from scrolling, while dragging. That makes it very hard to drop the part at the desired place.
Since I'm sure that can't be how it was meant to be programmed, I would be grateful, if someone coult point me to what I'm doing wrong or missing here...! 😃
Thanks so much!!

Advertising
3 participants
Avatar of lego11
Avatar of RainbowThunder
Avatar of Sealund

LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2024 The LEGO Group.

Mecabricks, the Mecabricks logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©2011-2024 Mecabricks.