Search 3D models
Problems with the new workshop update...
BionicleFan7 started this discussion in General Discussion
Avatar of BionicleFan7
BionicleFan7

I opened up Mecabricks for the first time in a while, and normally I don't have a problem with it. But after the update, the side part which allows you to change color, enter in new coordinates, and stuff like that is gone! Now I can't change color. Can anyone help me with this? (If it helps, I use Mecabricks on a Chromebook, the same place I always used it.)

4 replies · Page 1 of 1
Avatar of Scrubs
Scrubs
Administrator

Hello, there hasn't been any update recently. Lower down the zoom value of your browser until everything is visible.

Avatar of mancontro2012
mancontro2012

I can not open the designs of the gallery, nor can I do any type of design for two days, I see that new pieces have been put on and that the designer has been modified, and since then I can neither design nor see designs

Avatar of Scrubs
Scrubs
Administrator

https://www.mecabricks.com/en/forum/topic/1740

Avatar of mancontro2012
mancontro2012

thanks

Advertising
3 participants
Avatar of BionicleFan7
Avatar of Scrubs
Avatar of mancontro2012
Terms of Services
|
Privacy Policy
|
Contact Us
|

LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2024 The LEGO Group.

Mecabricks, the Mecabricks logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©2011-2024 Mecabricks.